• Sonuç bulunamadı

Check the linearity of the data 3

N/A
N/A
Protected

Academic year: 2021

Share "Check the linearity of the data 3"

Copied!
1
0
0

Yükleniyor.... (view fulltext now)

Tam metin

(1)

Assignment-2

Determination of correlation coefficient is based on two basic assumptions which are normal distribution and linearity. For the time series data you used in Assignment-1:

1. Plot a normal distribution function and check whether the data is normally distributed or not 2. Check the linearity of the data

3. Calculate autocorrelation coefficients for up to 12 lags (k) and plot the correlogram which is autocorrelation coefficient versus k. Also, comment on the relationship between autocorrelation coefficients and lags.

Istanbul Technical University Department of Civil Engineering

Hydraulics and Water Resources Engineering Graduate Program Stochastic Modelling Techniques in Hydrology

Spring Semester

Referanslar

Benzer Belgeler

Appendix 4.1 Table of the annual surface runoff (mcm) of the 10 rivers originating from Troodos Mountains.. Appendix 4.2 Table of the predicted annual surface runoff (mcm)

This chapter considers a system with two energy harvesting (EH) nodes transmitting to a common destination over a random access channel. The amount of harvested energy is as- sumed

Robot construction problem can be defined as a planning problem that asks for a final stable configuration of different types of prefabricated blocks stacked on each other that

They found that the wall superheat at ONB (onset of nucleate boiling) was essentially higher than that predicted with correlations for larger tubes. They concluded that an increase

Maximum Weight Scheduling can achieve throughput optimality by exploiting oppor- tunistic gain in general network topology with fading channels.. Despite the

The first condition,<p 11 0 , is related to the robot and is satisfied for a physical system since b > 0. Second condition, on the other hand, is related to the virtual

Next, we model the problem as that of network utility maximization, and provide a dynamic joint flow control, scheduling and secrecy encoding scheme under perfect and imperfect

Thowsen (1975) shows that order-up-to policies are optimal for the general multi-period problem, and obviously also for the single period case.. For the single period case, if