• Sonuç bulunamadı

BMT202 MESLEKİ YABANCI DİL 2 13.HAFTA

N/A
N/A
Protected

Academic year: 2021

Share "BMT202 MESLEKİ YABANCI DİL 2 13.HAFTA"

Copied!
9
0
0

Yükleniyor.... (view fulltext now)

Tam metin

(1)

BMT202 MESLEKİ

YABANCI DİL 2

13.HAFTA

GAMA MESLEK YÜKSEKOKULU

ÖĞR.GÖR.MEHMET DURSUN

(2)

Theory of Operation and System Architecture

………

General

………

This section contains a high level overview of the theory of operation of the major functional modules of the monitor.

……… ………

(3)

Philips service providers perform Bench Repair at the assembly level.

………

For this purpose, they should review this high level information.

………

Anyone wishing to perform component level repairs should review the detailed information provided in the Concepts Guide.

……… ………

(4)

Please be aware that Philips only stocks assembly level parts.

………

System Overview - A1

………

This section contains a system overview for the A1 monitor, including the overall block

………

diagram, power supply, isolated front end, NiBP control, the SpO2 processing module, and

………

(5)

Block Diagram - A1

………

The monitor contains an isolated front-end section, powered by an isolated power supply,

………

and in which the signals from SpO2, temperature, and ECG sensors are processed (see Figure 1).

………

The plastic tubing provides sufficient isolation for signals from the cuff in NiBP monitoring.

(6)

A single A/D converter is used to digitize processed temperature, NiBP, and ECG inputs; the

………

SpO2 module produces digitized data.

………

A microcontroller, Intel 386, requests and receives instructions from a flash memory.

………

The processor has a 16-bit data bus, and uses 19 of the 24-bit address bus.

(7)

These, and eight control signals, are used to read and write to the DRAM, flash memory,

………

UART, and FPGA (programmable gate array).

………

Other interface connections are made through the I/O port signals, timer signals, and interrupt signals.

………

The FPGA provides signals for control and data to the LCD.

(8)

Bias voltage and backlight power for the LCD are provided by the power supply section.

………

The FPGA processes front-panel button and A1 wheel operations.

………

Circuit details for these blocks are contained in the Concepts Guide.

(9)

Kaynakça:

Philips A1 and A3 Patient Monitors- Service Guide Service Guide.

Philips Medical Systems

Referanslar

Benzer Belgeler

If you roll up your sleeve, ensure it does not cause constriction of the blood flow in your upper

It ensures safe processes by means of the locking system which does not allow the

This key is used to set the speed and time during programming and to check the RCF value during the operation..

Connect the centrifuge to a correctly grounded power

• At the end of the adjusted time the motor stats to slow down and ‘br’ is seen on the speed

In case of a power cut or any defects, the instrument would be opened manually to be able to get the

Battery If the monitor has not been used for a long period of time, the battery will need.. Note Storing the monitor for a long period without charging the battery can

This section discusses the tests used to verify performance following repairs or during